Motor Bearing size? Castle 1410 3800Kv

[spookie]

Hey guys, I was wondering if anyone knew what bearing size goes in a Castle 1410 3800Kv 3.2mm motor? I had picked up a used motor awhile back and yesterday on the long maiden run, heard a light squealing coming from that area. But it quit before I could pin point it. So I thought I would go ahead and pick some up and replace the bearings. Thanks.

[flash]

Mar 18, 2014 14:37:04 GMT spookie said:

Hey guys, I was wondering if anyone knew what bearing size goes in a Castle 1410 3800Kv 3.2mm motor? I had picked up a used motor awhile back and yesterday on the long maiden run, heard a light squealing coming from that area. But it quit before I could pin point it. So I thought I would go ahead and pick some up and replace the bearings. Thanks.

Did you figure out what bearing goes on the motor?

[spookie]

Not yet, I googled it figuring someone has posted the size, but nothing yet. I guess I'll pull it apart and mike it.

[spookie]

Well found the problem, not the motor, one of the slipper pads self destructed. The parts fell into the bottom skid and were getting ground up.Notice how the small chuck ground on the spur?

[flash]

Mar 19, 2014 13:42:16 GMT spookie said:

Well found the problem, not the motor, one of the slipper pads self destructed. The parts fell into the bottom skid and were getting ground up.Notice how the small chuck ground on the spur?

Did you replace the bearing on the esc?